DDRC &= ~(1 << DDC3);		// Set PC3 to input for rotary dip

	DDRC &= ~(1 << DDC4);		// Set PC4 to input for rotary dip

	DDRC &= ~(1 << DDC5);		// Set PC5 to input for rotary dip

	DDRA &= ~(1 << DDA7);		// Set PA7 to input for battery voltage divider

	//ADC register configurations for battery level detection on PA7

	ADCSRA |= (1 << ADPS2) | (1 << ADPS1) | (1 << ADPS0);	// Set prescaler for ADC, 128 gives ADC freq of 125 KHz

	ADMUX |= (1 << REFS0);									// Set ADC reference voltage to AVCC

		//ADMUX |= (1 << ADLAR);								// Sets 10 bit ADC to 8 bit

	ADMUX |= (1 << MUX2) | (1 << MUX1) | (1 << MUX0);		// Select ADC7 as the conversion channel

	ADCSRA |= (1 << ADATE);									// Enables auto trigger, determined in ADCSRB bits ADTS

	moduleID = ((PINC & 0b00011100) >> 2);		// Read Dip Encoder

	moduleID = ~moduleID;						//Invert Dip reading

	moduleID = (moduleID & 0b0111);				//Mask bits

	*/

	while(moduleID==0)

	{

		moduleID = i2c_read(EEPROM_ADDR, 0x05);

	}

 }

 uint8_t io_getModuleId()

 {

	return moduleID;

void sensors_setupPressure(void);	// Reads pressure calibration values

void sensors_readSpiTemp(void);		// Reads spi temperature

void sensors_readBoardTemp(void);	// Reads board temperature

void sensors_readPressure(void);	// Reads pressure

void sensors_readHumid(void);		// Reads humidity

void sensors_readLux(void);			// Reads lux

int16_t sensors_getSpiTemp(void);	// Gets spi temperature from variable

int8_t sensors_getBoardTemp(void);	// Gets board temperature from variable

int32_t sensors_getPressure(void);	// Gets pressure from variable

uint16_t sensors_getHumid(void);	// Gets humidity from variable

uint32_t sensors_getLux(void);		// Gets lux from variable

int main(void)

{

	// Writes ID to EEPROM, change for all modules and delete after programming

	// 0 is for generic setup, 1 is for sensors, 2 is for Geiger, 3 is for cameras

	// Initialize		

	micro_setup();			// Generic microcontroller config options

	time_setup();			// Setup loop timer and interrupts (TIMER0)

	led_configure();		// Configure ports and registers for LED operation

	io_configure();			// Configure IO ports and registers