// Maximum payload size of command

#define MAX_PAYLOAD_LEN 16

// Number of datatypes to transmit per module type

#define DATATYPES_GENERIC 3

#define DATATYPES_SENSOR 8

#define DATATYPES_GEIGER 4

#define DATATYPES_CAMERA 3

//Sensors and IO

#define SENSOR_LOOP 200				// Frequency of sensor reads (in ms) (should be 200)

#define HEATER_THRESHOLD 0			// Temperature threshold in Fahrenheit where heater is activated

 //I2C Addresses

 #define EEPROM_ADDR 0xA0		// Read 0xA1 - Write 0xA0

 #define BOARDTEMP_ADDR 0x90	// Read 0x91 - Write 0x90

 #define PRESSURE_ADDR 0xEE		// Read 0xEF - Write 0xEE

 #define HUMID_ADDR 0x26		// Read 0x27 - Write 0x26

 #define LIGHT_ADDR 0x94		// Read 0x95 - Write 0x94

 #define ACCEL_ADDR	0x38		// Read 0x39 - Write 0x38

 #define RTC_ADDR 0xB2			//DEBUG [Used for testing]      // Read 0xA3 - Write 0xA2

 *  Author: kripperger

 */ 

 #include <inttypes.h>

 #include <avr/io.h>

 #include <avr/interrupt.h>

 #include "config.h"

 #include <util/delay.h>

 #include "modules.h"

 #include "lib/spi.h"

 #include "lib/i2c.h"

 #include "lib/sensors.h"

 void modules_setup(uint8_t id)

 {

	switch(id)

	{

		case 0:

			modules_generic_setup();

			break;

		case 1:

			modules_sensors_setup();

			break;

 }

 void modules_geiger()

 {

	// No data gatering function needed for geiger daughter board

		// This is taken care of in interrupt (See geiger.c)

 }

 void modules_cameras()

 {

	// Gathers data and performs functions for cameras daughter board

	{

		cameras_sendPulse();

	}

 }