sensors_readBatt();				// Read Battery level

			sensors_readBoardTemp();		// Read board temperature sensor (Common on all slaves) (Data Read)

			modules_run(io_getModuleId());	// Runs specific module functions (like data reading)

			io_regulateTemp();			// Gets board temperature and enables heater if below threshold

			snprintf(buff,128,"|ModuleID: %u |BoardTemp: %i |Millis: %lu |Lux: %lu |Pressure: %lu |Altitude: %lu |Battery: %u \r\n ",io_getModuleId(),sensors_getBoardTemp(),time_millis(),sensors_getLux(),sensors_getPressure(),sensors_getAltitude(),sensors_getBatt()); //DEBUG

			serial0_sendString(buff); //DEBUG

			_delay_ms(1);		// Delay to prevent the sensor loop from running again before time_millis changes

			led_off(0);

			led_off(2);

			//led_output(i2c_read(EEPROM_ADDR, 0x05));	// Debugging, delete

			//led_output(io_getModuleId());

		}

    }

	return 0;

}