ADMUX |= (1 << REFS0);									// Set ADC reference voltage to AVCC

	ADMUX |= (1 << ADLAR);									// Sets 10 bit ADC to 8 bit

	ADMUX |= (1 << MUX2) | (1 << MUX1) | (1 << MUX0);		// Select ADC7 as the conversion channel

	ADCSRA |= (1 << ADATE);									// Enables auto trigger, determined in ADCSRB bits ADTS

	//ADCSRA |= (1 << ADIF);									// 

//ADCSRA |= (1 << ADIE);									// ADC interrupt enable set

	ADCSRA |= (1 << ADEN);									// Enable ADC

	ADCSRA |= (1 << ADSC);									// Start ADC measurements.  ADC should now continuously run conversions, which are stored in ADCH 0x79

 }

void sensors_setupPressure(void);	// Reads pressure calibration values

void sensors_readSpiTemp(void);		// Reads spi temperature

void sensors_readBoardTemp(void);	// Reads board temperature

void sensors_readPressure(void);	// Reads pressure

void sensors_readHumid(void);		// Reads humidity

void sensors_readBatt(void);

int16_t sensors_getSpiTemp(void);	// Gets spi temperature from variable

int8_t sensors_getBoardTemp(void);	// Gets board temperature from variable

int32_t sensors_getPressure(void);	// Gets pressure from variable

uint16_t sensors_getHumid(void);	// Gets humidity from variable

uint32_t sensors_getLux(void);		// Gets lux from variable

int8_t sensors_getBatt(void);		// Gets battery voltage from variable

#endif /* SENSORS_H_ */

	}

 }

 void modules_run(uint8_t id)

 {

	switch(id)

	{

		case 0:

			modules_generic();

			break;

	// Gathers data and performs functions for sensor daughter board

	sensors_readBoardTemp();		//Data Read

	sensors_readSpiTemp();			//Data Read

	sensors_readPressure();			//Data Read

	//sensors_readHumid();			//Data Read

	sensors_readLux();				//Data Read

 }

 void modules_geiger()

 {

	// No data gatering function needed for geiger daughter board

			led_on(0);

			sensors_readBoardTemp();	// Read board temperature sensor (Common on all slaves) (Data Read)

			modules_run(io_getModuleId());		// Runs specific module functions (like data reading)

			io_regulateTemp();			// Gets board temperature and enables heater if below threshold

			serial0_sendString(buff); //DEBUG

			_delay_ms(2);		// Delay to prevent the sensor loop from running again before time_millis changes

			led_off(0);

			led_off(2);

		}