/*

	// This method is temporary as the next release will read the module ID from EEPROM

	PORTC |= (1 << PC2);	// Pull pins on rotary dip high

	PORTC |= (1 << PC3);	// Pull pins on rotary dip high

	PORTC |= (1 << PC4);	// Pull pins on rotary dip high

	PORTC |= (1 << PC5);	// Pull pins on rotary dip high

	moduleID = ((PINC & 0b00011100) >> 2);		// Read Dip Encoder

	moduleID = ~moduleID;						//Invert Dip reading

	moduleID = (moduleID & 0b0111);				//Mask bits

	*/

 }

 uint8_t io_getModuleId()

 {

	return moduleID;

 }

 void io_heaterOn()

 {		

	PORTB |= (1 << PB4);	//ON

int main(void)

{

	// Writes ID to EEPROM, change for all modules and delete after programming

	// 0 is for generic setup, 1 is for sensors, 2 is for Geiger, 3 is for cameras

	//i2c_write(EEPROM_ADDR, 0x05, 0x03);

	// Power debounce

	_delay_ms(20);

	// Initialize	

	micro_setup();			// Generic microcontroller config options

	time_setup();			// Setup loop timer and interrupts (TIMER0)

	led_configure();		// Configure ports and registers for LED operation

	io_configure();			// Configure IO ports and registers

	i2c_init();				// Setup I2C

	serial0_setup();		// Config serial port

	io_readModuleId();

	modules_setup(io_getModuleId());	// Run setup functions for specific module

	// Serial output //DEBUG

	char buff[128];						//Buffer for serial output //DEBUG

	serial0_sendString("Starting Slave\r\n");	//DEBUG

    while(1)

    {	

		// Master communication

		masterComm_checkParser();	//Checks parser for data requests from master

		// Main slave operations

		if ((time_millis() % SENSOR_LOOP) == 0)	// Uses program timer to run every so often. Time interval defined in config.h

		{

			led_on(0);

			sensors_readBatt();				// Read Battery level

			sensors_readBoardTemp();		// Read board temperature sensor (Common on all slaves) (Data Read)

			modules_run(io_getModuleId());	// Runs specific module functions (like data reading)

			io_regulateTemp();			// Gets board temperature and enables heater if below threshold

			snprintf(buff,128,"|ModuleID: %u |BoardTemp: %i |Millis: %lu |Lux: %lu |Pressure: %lu |Altitude: %lu |Battery: %u \r\n ",io_getModuleId(),sensors_getBoardTemp(),time_millis(),sensors_getLux(),sensors_getPressure(),sensors_getAltitude(),sensors_getBatt()); //DEBUG