//ADCSRA |= (1 << ADIF);								// 

	//ADCSRA |= (1 << ADIE);								// ADC interrupt enable set

	ADCSRB &= ~((1 << ADTS2) | (1 << ADTS1) | (1 << ADTS0));// Set ADC auto trigger source to free running mode

	ADCSRA |= (1 << ADEN);									// Enable ADC

	ADCSRA |= (1 << ADSC);									// Start ADC measurements.  ADC should now continuously run conversions, which are stored in ADCH 0x79

 }

 void io_readModuleId()

 {

	// Get ID from rotary dip and return it. 

	/*

	// This method is temporary as the next release will read the module ID from EEPROM

	PORTC |= (1 << PC2);	// Pull pins on rotary dip high

	PORTC |= (1 << PC3);	// Pull pins on rotary dip high

	PORTC |= (1 << PC4);	// Pull pins on rotary dip high

	PORTC |= (1 << PC5);	// Pull pins on rotary dip high

	moduleID = ((PINC & 0b00011100) >> 2);		// Read Dip Encoder

	moduleID = ~moduleID;						//Invert Dip reading

	moduleID = (moduleID & 0b0111);				//Mask bits

	*/

 }

 void modules_sensors_setup()

 {

	DESELECT_TEMP;

	setup_spi();

	sensors_setupPressure();

 }

 void modules_geiger_setup()

 {

	// Pin setup

	//DDRA |= (1 << DDA1);	// PA1 is an output	///////////

	//geiger_on();	// Turn on HV supply	//////////////

	// Setup for interrupt input on PA0 (PCINT0)

	// Setup for interrupt from Timer2

	ASSR &= ~(1 << EXCLK);	// Disable external clock input (enabling crystal use)

	ASSR |= (1 << AS2);		// Enable timer2 async mode with an external crystal	

	_delay_ms(100);			// Let external 32KHz crystal stabilize

	TCCR2B = 0x05;			// Set the prescaler to 128: 32.768kHz / 128 = 1Hz overflow

	TIFR2 = 0x01;			// Reset timer2 overflow interrupt flag

	TIMSK2 = 0x01;			// Enable interrupt on overflow

 }

	// Gathers data and performs functions for generic daughter board

 }

 void modules_sensors()

 {

	// Gathers data and performs functions for sensor daughter board

	sensors_readBoardTemp();		//Data Read

	sensors_readSpiTemp();			//Data Read	

	sensors_readPressure();			//Data Read

	//sensors_readHumid();			//Data Read

 }

 void modules_geiger()

 {

	// No data gatering function needed for geiger daughter board

		// This is taken care of in interrupt (See geiger.c)

		//lastRefresh = time_millis();

		//if ((time_millis() - lastRefresh) > 1000000)

		//{

		//	geiger_refresh();	//Refreshes every 1000sec (16min)