/** EMZ we only really need COM1, EVAL_COM1, 
  ******************************************************************************
  * @file    stm32l152d_eval.h
  * @author  MCD Application Team
  * @version V1.0.1
  * @date    09-March-2012
  * @brief   This file contains definitions for STM32L152D_EVAL's Leds, push-buttons
  *          COM ports and Temperature Sensor LM75 (on I2C) hardware resources.  
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT 2012 STMicroelectronics</center></h2>
  *
  * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
  * You may not use this file except in compliance with the License.
  * You may obtain a copy of the License at:
  *
  *        http://www.st.com/software_license_agreement_liberty_v2
  *
  * Unless required by applicable law or agreed to in writing, software 
  * distributed under the License is distributed on an "AS IS" BASIS, 
  * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
  * See the License for the specific language governing permissions and
  * limitations under the License.
  *a
  ******************************************************************************
  */
  
/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef __STM32L152D_EVAL_H
#define __STM32L152D_EVAL_H

#ifdef __cplusplus
 extern "C" {
#endif 

/* Includes ------------------------------------------------------------------*/
#include "stm32l1xx.h"

typedef enum 
{
  COM1 = 0,
  COM2 = 1
} COM_TypeDef;   
/**
  * @}
  */ 

#define COMn                             1

/**
 * @brief Definition for COM port1, connected to USART1
 */ 
#define EVAL_COM1                        USART1
#define EVAL_COM1_CLK                    RCC_APB2Periph_USART1

#define EVAL_COM1_TX_PIN                 GPIO_Pin_9
#define EVAL_COM1_TX_GPIO_PORT           GPIOA
#define EVAL_COM1_TX_GPIO_CLK            RCC_AHBPeriph_GPIOA
#define EVAL_COM1_TX_SOURCE              GPIO_PinSource9
#define EVAL_COM1_TX_AF                  GPIO_AF_USART1

#define EVAL_COM1_RX_PIN                 GPIO_Pin_10
#define EVAL_COM1_RX_GPIO_PORT           GPIOA
#define EVAL_COM1_RX_GPIO_CLK            RCC_AHBPeriph_GPIOA
#define EVAL_COM1_RX_SOURCE              GPIO_PinSource10
#define EVAL_COM1_RX_AF                  GPIO_AF_USART1

#define EVAL_COM1_IRQn                   USART1_IRQn


/** @defgroup STM32L152D_EVAL_LOW_LEVEL_Exported_Functions
  * @{
  */ 
void STM_EVAL_COMInit(COM_TypeDef COM, USART_InitTypeDef* USART_InitStruct);
#ifdef __cplusplus
}
#endif
  
#endif /* __STM32L152D_EVAL_H */
/**
  * @}
  */ 

/**
  * @}
  */ 

/**
  * @}
  */

/**
  * @}
  */
  
/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/