//USB_Interrupts_Config();

    //USB_Init();

    GPIO_SetBits(LED_POWER);

    RCC_ClocksTypeDef RCC_Clocks;

    // SysTick end of count event each 1ms

    RCC_GetClocksFreq(&RCC_Clocks);

    SysTick_Config(RCC_Clocks.HCLK_Frequency / 1000);

    GPIO_ResetBits(LED_STAT);

    Delay(100);

    GPIO_SetBits(LED_POWER);

    Delay(500);

    GPIO_ResetBits(LED_POWER);

    init_spi();

    ssd1306_Init();

    ssd1306_block_write();

    ssd1306_DrawString("Hello World!", 0, 10);

  //  ssd1306_block_write();

    while(1)

   {  

        //ssd1306_block_write();

        // Process sensor inputs [TODO: 5hz?]

        process();

        // Run state machine [TODO: 50hz?]

        machine(); 

        // probably just passed the actual port

        // TODO: Grab buttonpresses with interrupts

        uint8_t sw_btn = GPIO_ReadInputDataBit(SW_BTN);

        uint8_t sw_up = GPIO_ReadInputDataBit(SW_UP);

        uint8_t sw_down = GPIO_ReadInputDataBit(SW_DOWN);

        uint8_t sw_left = GPIO_ReadInputDataBit(SW_LEFT);

        uint8_t sw_right = GPIO_ReadInputDataBit(SW_RIGHT);

        if(!sw_btn) {

            GPIO_ToggleBits(LED_STAT);

        }

        GPIO_SetBits(LED_POWER);

        Delay(50);

        GPIO_ResetBits(LED_POWER);

        Delay(50);

    }

}

int32_t temp = 0;

int32_t setpoint = 0;

int32_t p = 1;

int32_t i = 1;

int32_t d = 1;

// Process things

void process()

{

    // Read MAX temp sensor

    GPIO_ResetBits(MAX_CS);

    // Assert CS

    // This may not clock at all... might need to send 16 bits first

    uint8_t retval = 0;//SPI_I2S_ReceiveData(SPI2);