diff --git a/Libraries/u8glib/u8g_arm.c b/Libraries/u8glib/u8g_arm.c
new file mode 100644
--- /dev/null
+++ b/Libraries/u8glib/u8g_arm.c
@@ -0,0 +1,63 @@
+uint8_t u8g_com_hw_i2c_fn(u8g_t *u8g, uint8_t msg, uint8_t arg_val, void *arg_ptr)
+{
+
+  switch(msg)
+  {
+    case U8G_COM_MSG_STOP:
+      break; //do nothing...
+
+    case U8G_COM_MSG_INIT:
+      i2c_init(); //inits the i2c hardware, gpios and timers
+      u8g_MicroDelay();      
+      break;
+
+    case U8G_COM_MSG_ADDRESS: 
+      //the control byte switches the mode on the device and is set here
+      if (arg_val == 0)
+      {
+    	  control = 0;
+      }
+      else
+      {
+    	  control = 0x40;
+      }
+      u8g_10MicroDelay();
+     break;
+
+    case U8G_COM_MSG_RESET:
+      //pin 9 is my reset pin
+      GPIO_WriteBit(GPIOB, GPIO_Pin_9, arg_val);
+      u8g_10MicroDelay();
+      break;
+
+    case U8G_COM_MSG_WRITE_BYTE:
+      //simple: just write one byte
+      i2c_out(arg_val);
+      u8g_MicroDelay();
+      break;
+
+    case U8G_COM_MSG_WRITE_SEQ:
+    case U8G_COM_MSG_WRITE_SEQ_P:
+      {
+        register uint8_t *ptr = arg_ptr;
+        //send the control byte (to switch from command to data mode)
+        I2C_start(SSD1306_I2C_ADDRESS, I2C_Direction_Transmitter);
+    	I2C_SendData(I2C2, control);
+    	while(!I2C_CheckEvent(I2C2, I2C_EVENT_MASTER_BYTE_TRANSMITTED));
+
+        //now send the rest of data
+        while( arg_val > 0 )
+        {
+        	I2C_SendData(I2C2, *ptr++);
+        	arg_val--;
+        	while(!I2C_CheckEvent(I2C2, I2C_EVENT_MASTER_BYTE_TRANSMITTED));
+        }
+        //done
+    	I2C_stop();
+        u8g_MicroDelay();
+      }
+      break;
+
+  }
+  return 1;
+}