diff --git a/platform_config.h b/platform_config.h
deleted file mode 100644
--- a/platform_config.h
+++ /dev/null
@@ -1,62 +0,0 @@
-/**
-  ******************************************************************************
-  * @file    platform_config.h
-  * @author  MCD Application Team
-  * @version V4.0.0
-  * @date    21-January-2013
-  * @brief   Evaluation board specific configuration file.
-  ******************************************************************************
-  * @attention
-  *
-  * <h2><center>&copy; COPYRIGHT 2013 STMicroelectronics</center></h2>
-  *
-  * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
-  * You may not use this file except in compliance with the License.
-  * You may obtain a copy of the License at:
-  *
-  *        http://www.st.com/software_license_agreement_liberty_v2
-  *
-  * Unless required by applicable law or agreed to in writing, software 
-  * distributed under the License is distributed on an "AS IS" BASIS, 
-  * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-  * See the License for the specific language governing permissions and
-  * limitations under the License.
-  *
-  ******************************************************************************
-  */
-
-
-/* Define to prevent recursive inclusion -------------------------------------*/
-#ifndef __PLATFORM_CONFIG_H
-#define __PLATFORM_CONFIG_H
-
-/* Includes ------------------------------------------------------------------*/
-#include "stm32f0xx.h"
-
-/* Exported types ------------------------------------------------------------*/
-
-/*Unique Devices IDs register set*/
-#define         ID1          (0x1FF80050)
-#define         ID2          (0x1FF80054)
-#define         ID3          (0x1FF80064)
-
-#if !defined(USB_USE_EXTERNAL_PULLUP)
-  #define STM32L15_USB_CONNECT                SYSCFG_USBPuCmd(ENABLE)
-  #define STM32L15_USB_DISCONNECT             SYSCFG_USBPuCmd(DISABLE)
-
-#elif defined(USB_USE_EXTERNAL_PULLUP)
-  /* PA0 is chosen just as illustrating example, you should modify the defines
-    below according to your hardware configuration. */ 
-  #define USB_DISCONNECT                      GPIOA
-  #define USB_DISCONNECT_PIN                  GPIO_Pin_0
-  #define RCC_AHBPeriph_GPIO_DISCONNECT       RCC_AHBPeriph_GPIOA
-  #define STM32L15_USB_CONNECT                GPIO_ResetBits(USB_DISCONNECT, USB_DISCONNECT_PIN)
-  #define STM32L15_USB_DISCONNECT             GPIO_SetBits(USB_DISCONNECT, USB_DISCONNECT_PIN)
-#endif /* USB_USE_EXTERNAL_PULLUP */
-
-/* Exported macro ------------------------------------------------------------*/
-/* Exported functions ------------------------------------------------------- */
-
-#endif /* __PLATFORM_CONFIG_H */
-
-/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/