//
// Depth Select Configuration
//

#ifndef CONFIG_H
#define CONFIG_H


// --------------------------------------------------------------------------
// Transmitter config (si446x.c)
// --------------------------------------------------------------------------

// Transmit power (0-0x7F, 0mW - 40mw?)
#define SI446x_POWER 0x40 // 0x40 for jake launch

#define TUNE_FREQUENCY 433500000UL


// Internal macros
#define hal_init HAL_Init


// Uncomment if using legacy LPS25h pressure sensor
//#define LPS25H


#define FRIENDLY_MODE
#define FRIENDLY_TIMEOUT  1800 // 1800 // seconds before reducing tx rate
#define FRIENDLY_TX_RATE 60000 // milliseconds tx rate after timeout elapsed

// --------------------------------------------------------------------------
// ADC config (adc.c)
// --------------------------------------------------------------------------

// Temperature sensor offset (die temperature from ambient, esimate, in Celcius)
#define ADC_TEMPERATURE_OFFSET -10


// --------------------------------------------------------------------------
// AX.25 config (ax25.c)
// --------------------------------------------------------------------------

// TX delay in milliseconds
#define TX_DELAY      70

// Maximum packet delay
#define MAX_PACKET_LEN 512  // bytes


// --------------------------------------------------------------------------
// APRS config (aprs.c)
// --------------------------------------------------------------------------

// Set your callsign and SSID here. Common values for the SSID are
// (from http://zlhams.wikidot.com/aprs-ssidguide):
//
// - Balloons:  11
// - Cars:       9
// - Home:       0
// - IGate:      5
#define S_CALLSIGN      "S"
#define S_CALLSIGN_ID   1

// Destination callsign: APRS (with SSID=0) is usually okay.
#define D_CALLSIGN      ""
#define D_CALLSIGN_ID   0

// Digipeating paths:
// (read more about digipeating paths here: http://wa8lmf.net/DigiPaths/ )
// The recommended digi path for a balloon is WIDE2-1 or pathless. The default
// is pathless. Uncomment the following two lines for WIDE2-1 path:
//#define DIGI_PATH1      "WIDE2"
//#define DIGI_PATH1_TTL  1

// Transmit the APRS sentence every X milliseconds
#define APRS_TRANSMIT_PERIOD 1000





#endif

// vim:softtabstop=4 shiftwidth=4 expandtab