//

// Depth Select Configuration

//

#ifndef CONFIG_H

#define CONFIG_H

// --------------------------------------------------------------------------

// Transmitter config (si446x.c)

// --------------------------------------------------------------------------

#define TUNE_FREQUENCY 433000000UL

// Internal macros

#define hal_init HAL_Init

// --------------------------------------------------------------------------

// ADC config (adc.c)

// --------------------------------------------------------------------------

// Temperature sensor offset (die temperature from ambient, esimate, in Celcius)

#define ADC_TEMPERATURE_OFFSET -10

// --------------------------------------------------------------------------

// AX.25 config (ax25.c)

// --------------------------------------------------------------------------

// TX delay in milliseconds

#define TX_DELAY      70

//    };

//    si446x_sendcmd(5, tune_xo_cmd, SI446x_CHECK_ACK);

    HAL_Delay(10);

    // Tune to frequency specified

	si446x_setchannel(TUNE_FREQUENCY);

	HAL_Delay(10);

    // Set to 2FSK mode

    uint8_t modemconfig = SI446x_MOD_TYPE_2FSK | SI446x_MOD_TYPE_SOURCE_DIRECTMODE | SI446x_MOD_TYPE_DIRECT_ASYNCH | SI446x_MOD_TYPE_DIRECT_SOURCE_GPIO1; //SI446x_MOD_TYPE_SOURCE_PACKETHANDLER

    uint8_t set_modem_mod_type_command[] = {

    		SI446x_CMD_SET_PROPERTY,

    		SI446x_MOD_TYPE_REGISTER_GROUP,

			0x01, // num data

			SI446x_MOD_TYPE_REGISTER_PROP,

			modemconfig

    };

    si446x_sendcmd(5, set_modem_mod_type_command, SI446x_CHECK_ACK);

    HAL_Delay(10);

	// Set Si446x initial output power, input to power amp (0-0x7F, 0mW - 40mw?)

	// FIXME: basepower should be 0x10 for underperforming units and 0x04 for normal units

    uint8_t set_power_level_command[] = {SI446x_CMD_SET_PROPERTY, 0x22, 0x01, 0x01, basepower};

	si446x_sendcmd(5, set_power_level_command, SI446x_CHECK_ACK);

	HAL_Delay(10);

    // Set air data rate

    si446x_setdatarate();

    HAL_Delay(10);

	// Tune TX

	uint8_t change_state_command[] = {SI446x_CMD_CHANGE_STATE, 0x05}; //  Change to TX tune state

    si446x_sendcmd(2, change_state_command, SI446x_CHECK_ACK);

    HAL_Delay(10);

	si446x_cw_status = 0;

}

// Perform power-on-reset of Si446x. Takes 20ms.

void si446x_reset(void)

{

	si446x_shutdown();