_delay_ms(20);

	// Initialize	

	micro_setup();			// Generic microcontroller config options

	time_setup();			// Setup loop timer and interrupts (TIMER0)

	//watchdog_setup();		// Setup watchdog timer

	led_configure();		// Configure ports and registers for LED operation

	io_configure();			// Configure IO ports and registers

	i2c_init();				// Setup I2C

	serial0_setup();		// Config serial port

	io_readModuleId();

	modules_setup(io_getModuleId());	// Run setup functions for specific module

	// Serial output //DEBUG

	char buff[128];						//Buffer for serial output //DEBUG

	serial0_sendString("Starting Slave\r\n");	//DEBUG

    while(1)

    {	

		// Master communication

		masterComm_checkParser();	//Checks parser for data requests from master

		// Main slave operations

		if ((time_millis() % SENSOR_LOOP) == 0)	// Uses program timer to run every so often. Time interval defined in config.h

		{

			led_on(0);

			sensors_readBatt();				// Read Battery level

			sensors_readBoardTemp();		// Read board temperature sensor (Common on all slaves) (Data Read)

			modules_run(io_getModuleId());	// Runs specific module functions (like data reading)

			io_regulateTemp();			// Gets board temperature and enables heater if below threshold

			_delay_ms(1);		// Delay to prevent the sensor loop from running again before time_millis changes

			led_off(0);

			led_off(2);

			//led_output(i2c_read(EEPROM_ADDR, 0x05));	// Debugging, delete

			//led_output(io_getModuleId());

		}

    }

	return 0;

}

		/********Examples of data reading and getting******************

		x = geiger_getCpm();				//Data get

		x = sensors_getSpiTemp();			//Data get

		x = sensors_getBoardTemp();			//Data get

		sensors_readSpiTemp();				//Data Read